Heya all. I am trying to set up a friends Freeduino and having no luck uploading. Heres the condiions:
Pre-assembled Freeduino BBB Rev D2 with ATMega168
Both Jumpers set to EXT.
+5v and GND connected according to marks on the board right beside the RST pin.
Board LED turns on when power is applied.
When power is first applied an LED (connected with 1k resistor) to pin 13 blinks a few times.
When clicking the reset button the LED on pin 13 does not blink.
*EDIT* I tested again and I think this one only blinks when reset is pressed first after power on and maybe when recieving new program*
FDTI TTL-232-USB cable pluged in with Black Wire matching to GND.
FDTI Drivers installed and Recognized When plugged into PC.
Loppback Test from PC To AVR socket pins 1 and 2 echo properly.
When attempting to upload via Arduino software I recieved standard no-sync and bad protocol errors.
Any clue what else I can do?