Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: garriwilson on July 21, 2007, 10:39:15 AM
-
Ok I got the 34 dollar programmer. I know the arrow points to pin 1 but is it the one on top close to the arrow or the one on the bottom?
-
The arrow is pointing towards pin 1 - its the one on the same side of the connector as the arrow is.
- Jon
-
If you can see the soldered side of the board, pin 1 is usually soldered in a square patch and the rest are in the normal circle patch.
-
(http://www.societyofrobots.com/images/sbs_ICSP_header.JPG)
-
Ok thanks guys you did it again!