Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: Robotics12 on April 06, 2012, 11:21:03 PM

Title: Current output for motor controller
Post by: Robotics12 on April 06, 2012, 11:21:03 PM

Ok, so I am using this motor driver:
http://www.pololu.com/catalog/product/1373 (http://www.pololu.com/catalog/product/1373)

I see it only has 7A continuous peak without heat sink. My motor will be around the 7A continuous mark and was wondering if anyone had knowledge of applying epoxy/heat sink or fan to the motor controller.