Author Topic: Wiring for $50 robot, pic "sbs_connect7_large.JPG"  (Read 1363 times)

0 Members and 1 Guest are viewing this topic.

Offline cas64Topic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Wiring for $50 robot, pic "sbs_connect7_large.JPG"
« on: July 10, 2010, 07:48:01 AM »
I have a question about the wiring that is shown on the following pic that comes from the SoR website:
http://www.societyofrobots.com/images/sbs_connect7_large.JPG

When I got to this step in the build, I did not have anything on the front side of my PC board in hole 11B, which is where the purple wire in the picture connects.

Is that a problem?

Here is how the back of my PC board looks if that helps: http://www.flickr.com/photos/51217215@N02/4779400431/#
and here is a pic of the front side: http://www.flickr.com/photos/51217215@N02/4779400877/#

Thanks!
Logged

Offline billhowl

  • Supreme Robot
  • *****
  • Posts: 376
  • Helpful? 32
  • Your success is in your hands.
Re: Wiring for $50 robot, pic "sbs_connect7_large.JPG"
« Reply #1 on: July 10, 2010, 08:45:02 PM »
To the PC board in hole 8B and NOT 11B, this is the output of the 5V voltage regulator to the middle row of the sensor power bus.
« Last Edit: July 10, 2010, 08:47:03 PM by billhowl »
Logged

Offline Alfa_Zulu

  • Full Member
  • ***
  • Posts: 92
  • Helpful? 1
Re: Wiring for $50 robot, pic "sbs_connect7_large.JPG"
« Reply #2 on: July 10, 2010, 09:50:33 PM »
nah thats fine, the purple wire takes 5V regulated power from the voltage regulator to the centre row of pins in the inputs header, it just goes to 11b but it actually connects to 12B-17B
Logged