What are USART settings for Axon Mote (channel 0) to operate properly with on-board FT232R USB bridge?
- character size (looks like 8 bit is used)
- parity bit mode (even or odd, if supported at all),
- baud rate,
- etc.
Does FT232R operates in synchronous or asynchronous mode with Axon Mote?
Does FT232R wired to support duplex transmission with Axon Mote?
We are trying to program UART "manually", e.g. we do not use WebBotLib in our project. So we need a setup configuration for on-boar USART port 0, that is connected to the USB bridge.
If no information available, will have to dig into WebBotLib generated project to get default working settings. However knowing all the supported options would be very helpful.
PS: Could someone please add this information to the Axon Mote datasheet page?
PPS: Datasheet link to Atmel website is also outdated. New one is
http://www.atmel.com/devices/atmega128rfa1.aspx?tab=documents