Society of Robots - Robot Forum

Electronics => Electronics => Topic started by: aventgps on October 12, 2009, 09:23:33 AM

Title: it works!!!! ARDUINO
Post by: aventgps on October 12, 2009, 09:23:33 AM

hello, i have got a severino board allready asembled with an atmega328 chip on, it came with a prototype shield to make everything easier.... the question is, i see only 3 pwm pins on the board: 9,10,11.... and the atmega328 reference manual says it has 6 pwm pins: 9,10,11 and 3,5,6. how can i use the other pwm on the severino board?
pics of my severino on my very first proyect. :D

(http://img517.imageshack.us/img517/1748/s4025515.jpg)

(http://img515.imageshack.us/img515/5585/s4025512.jpg)

hope you can help, i want to control 6 servos with my severino, ans sorry about the mess ober the board  :-[

Title: Re: it works!!!! ARDUINO
Post by: SmAsH on October 12, 2009, 11:21:34 PM

The 328 does have 6 pwm pins, they might just not have it marked?
Your right on the pins too, give it a go running pwm and see if it works, it should.