Author Topic: AVRISP mk2  (Read 2716 times)

0 Members and 1 Guest are viewing this topic.

Offline GeirTopic starter

  • Jr. Member
  • **
  • Posts: 27
  • Helpful? 0
AVRISP mk2
« on: March 06, 2008, 04:22:25 PM »
Hi!

I just bought the AVRISP mk2 programmer and a ATmega168. First time i got the pins from the programmer wrong and it started blinking. But i reconnected every ting and it looks fine. But the led is always red i cant get avrstudio to connect to target. It connects to the programmer but not to Atmega. Can find the problem, im running on 3.3v, and i tryd just plugging the vdd and gnd from the programmer to 3.3 and look at the Vtarget and it reads 0.0v OK. Any one know whats wrong have i fried it?
Logged
$50 Robot schematic http://elektro.russemotto.com

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: AVRISP mk2
« Reply #1 on: March 11, 2008, 06:37:44 AM »
Did you reverse ground and power when you got the pins wrong? (but I dont think that will break it)

Its a solid red LED?

When it was blinking, what color was it? Orange?

It sounds like your wiring is not correct, or that you have an intermittent connection.
Logged