Society of Robots - Robot Forum
Electronics => Electronics => Topic started by: conqueror06 on December 15, 2009, 09:45:27 AM
-
Hello! 8)
I bought few days ago a 10A Dual H-Bridge from
http://www.roboticsconnection.com/p-77-10-amp-dual-h-bridge.aspx (http://www.roboticsconnection.com/p-77-10-amp-dual-h-bridge.aspx).
I want to ask if it is possible to connect the H-Bridge to Basic Stamp 2 for controlling two DC motors.
What are the precise connections between Board of Education and 10A Dual H-Bridge?
Finally, how can I program it?
Sorry if I bore you with my questions, but I'm just a begginer!!! ;D
-
Hello! 8)
I bought few days ago a 10A Dual H-Bridge from
http://www.roboticsconnection.com/p-77-10-amp-dual-h-bridge.aspx (http://www.roboticsconnection.com/p-77-10-amp-dual-h-bridge.aspx).
I want to ask if it is possible to connect the H-Bridge to Basic Stamp 2 for controlling two DC motors.
What are the precise connections between Board of Education and 10A Dual H-Bridge?
Finally, how can I program it?
Sorry if I bore you with my questions, but I'm just a beginner!!! ;D
-
The pins of the H-Bridge:
Vcc - Logic Vcc (+5V)
Gnd
DIR1 - Motor direction for motor 1 (High/Low)
PWM1 - PWM Input for motor 1
DIR2 - Motor direction for motor 2 (High/Low)
PWM2 - PWM Input for motor 2
Enbl. - H-Bridge Enable