Author Topic: ooPic R and L297/L298 for Stepper  (Read 4131 times)

0 Members and 1 Guest are viewing this topic.

Offline vivek9856Topic starter

  • Jr. Member
  • **
  • Posts: 43
  • Helpful? 0
ooPic R and L297/L298 for Stepper
« on: March 03, 2009, 08:37:26 PM »
I am using an ooPic R to control a L297 which drives an L298 which drives a stepper motor. I'm trying to figure out how to get the correct clock signal out of the ooPic.

First off, I would need to use the oFreq object to generate a clock signal for the L297, correct? Or does the L297 use PWM on the clock line?

Secondly, I would need to use the oFreqH object on the Pic to get a high enough frequency to drive the L297. However, a speaker is connected to Line 21 on the R board. How can I remove the speaker and connect an I/O pin? I tried removing the solder on the back of the speaker and pulling, but it didn't move. Is it glued down?

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: ooPic R and L297/L298 for Stepper
« Reply #1 on: March 24, 2009, 11:54:29 PM »
This sounds incredibly overcomplicated . . . is there a reason you didn't buy a $15 stepper motor driver?
http://www.sparkfun.com/commerce/product_info.php?products_id=8368

 :P

 


Get Your Ad Here