Author Topic: H-Bridge with Two 2-way Motor control  (Read 3142 times)

0 Members and 1 Guest are viewing this topic.

Offline Icewind007Topic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
H-Bridge with Two 2-way Motor control
« on: May 03, 2007, 09:53:09 PM »
I am using the SN754410 QUADRUPLE HALF-H DRIVER.  It says it can be used with two 2 directional motors.  I am not very familiar with how to work with these but I managed to use an entire one of these H-bridges to get one motor going two directions.  Could I get any tips  or schematics on how to properly get this one h-bridge to run two motors in two directions?  The specs are at this website.


http://info.hobbyengineering.com/specs/SN754410.pdf

Offline JonHylands

  • Expert Roboticist
  • Supreme Robot
  • *****
  • Posts: 562
  • Helpful? 3
  • Robot Builder/ Software Developer
Re: H-Bridge with Two 2-way Motor control
« Reply #1 on: May 03, 2007, 10:00:16 PM »
Check out the schematic on my Seeker 2 page:

http://www.huv.com/miniSumo/seeker2/Schematic.gif

- Jon

Offline ed1380

  • Supreme Robot
  • *****
  • Posts: 1,478
  • Helpful? 3
Re: H-Bridge with Two 2-way Motor control
« Reply #2 on: May 08, 2007, 02:14:43 PM »
Check out the schematic on my Seeker 2 page:

http://www.huv.com/miniSumo/seeker2/Schematic.gif

- Jon

that looks like a mixture of these 2  http://www.allegromicro.com/en/Products/Part_Numbers/2981/index.asp and http://www.allegromicro.com/en/Products/Part_Numbers/2559/index.asp

according to your link "K" on my second link could be "Rc2" and "Rc3"
Problems making the $50 robot circuit board?
click here. http://www.societyofrobots.com/robotforum/index.php?topic=3292.msg25198#msg25198

Offline JonHylands

  • Expert Roboticist
  • Supreme Robot
  • *****
  • Posts: 562
  • Helpful? 3
  • Robot Builder/ Software Developer
Re: H-Bridge with Two 2-way Motor control
« Reply #3 on: May 08, 2007, 02:58:53 PM »
Well, its not, its a single SN754410, which is why I pointed it out...

- Jon

 


Get Your Ad Here