Squirrels have fuzzy tails.
0 Members and 1 Guest are viewing this topic.
When I initiate the bootloader, then power the MCU the bootloader doesn't come out of the idle state.
the usb pins and they are 1.0V, 0.07V, and 4.76V. Pins were read from the center pin to the outside pin, ignoring the ground pins. While testing these pins I noticed that the CP210x USB to UART Bridge is very hot.
I did connect the power to the 3.3V output momentarily.
Started by Dmntd1
Started by Ryltar
Started by teoxan
Started by ambcorp2000