I have a sabertooh and I'm following the tank control example to be tested in a axon2 ...
I tried yesterday and it was not a successful, I used UART 0 and connect transmitter in S1 and receiver in S2, both ground connected. I used a simple serial connection … I need help.
Which configuration should I use for this.
1- Which Port in the microcontroller
What baud rate if need it ??
2- Which configuration in the Motor drive
3- Which Port in the Sabertooth S1 and S2 or only S1
Help will be gladly accepted … I will post a cool video of what I’m doing if I get this solve …