This week I found out the an Arduino can be used as an AVR ISP programmer and decided to try to program my Axon II with it. http://arduino.cc/en/Tutorial/ArduinoISP
The diagrams in the link are for uploading the Arduino bootloader to another Arduino, but after looking at the Arduino forum I found that:
pin10: slave reset
pin 11: MOSI
pin 12: MISO
pin 13: SCK
I also connected the GND on the Arduino to the GND on the ISP header and the 5v on the Arduino to the Vcc on the header.
Did I do everything right? Don't want to fry anything.
Which way do I plug in the header; I marked the GND pin, but I obviously don't have the red wire that's on standard ISP cables.