go_away

Author Topic: How to replace DPDT slide switch with a wire?  (Read 836 times)

0 Members and 1 Guest are viewing this topic.

Offline Melcin PowellTopic starter

  • Full Member
  • ***
  • Posts: 61
  • Helpful? 0
How to replace DPDT slide switch with a wire?
« on: August 28, 2011, 12:21:58 PM »
I know this should be common knowledge, but i do not understand how i could replace the switch with the wire. Please inform how to replace the switch with a wire so as the device would be on while it is plugged in.

Thank you

Offline Soeren

  • Supreme Robot
  • *****
  • Posts: 4,672
  • Helpful? 227
  • Mind Reading: 0.0
Re: How to replace DPDT slide switch with a wire?
« Reply #1 on: August 28, 2011, 05:16:31 PM »
Hi

I know this should be common knowledge, but i do not understand how i could replace the switch with the wire. Please inform how to replace the switch with a wire so as the device would be on while it is plugged in.
You really want the fish on that one?

Here's the pole...
Ask yourself what the purpose of the switch is and how you'd draw a switch as well as how you'd draw a wire(/short).
Regards,
Søren

A rather fast and fairly heavy robot with quite large wheels needs what? A lot of power?
Please remember...
Engineering is based on numbers - not adjectives

Offline Melcin PowellTopic starter

  • Full Member
  • ***
  • Posts: 61
  • Helpful? 0
Re: How to replace DPDT slide switch with a wire?
« Reply #2 on: September 01, 2011, 09:00:05 PM »
Thank you so much i was able to figure out.

 


Get Your Ad Here

data_list