Author Topic: Beagleboard and Atmega8 Communication  (Read 1114 times)

0 Members and 1 Guest are viewing this topic.

Offline spizzakTopic starter

  • Full Member
  • ***
  • Posts: 102
  • Helpful? 1
Beagleboard and Atmega8 Communication
« on: September 21, 2011, 06:38:07 PM »
Hi all, I'm working on a project where a BeagleBoard needs to communicate with my Atmega8 which is doing servo control. Can someone suggest what the best interface or method for this would be?


Offline msprague

  • Jr. Member
  • **
  • Posts: 35
  • Helpful? 1
Re: Beagleboard and Atmega8 Communication
« Reply #1 on: September 24, 2011, 03:20:34 PM »
You will probably want to use a level shifter since the most of the IO on the BeagleBoard is a 1.8V device.  You can use a level shifter.  For an idea, look at the schematic linked on this page for the tincan trainer board for a sample of Atmega328 interfacing to the BeagleBoard.  Maybe it is worth the investment in that trainer board if you want to do other interfacing to the BeagleBoard.


Get Your Ad Here