Connecting to Breadboard

[rahulpwns]

Hey guys,
I am working on a project where i am disassembling an RC Car and using the parts inside to create an autonomous vehicle. I am planning on cutting the wires from the motor and connecting them to my own breadboard. However, these wires are too thin and will not fit snugly into the breadboard. How can i connect the wires from the motor to the breadboard? Is there a way for me to solder them onto a jumper wire? Should i replace the original wire with a higher gauge wire?

Thanks,
Rahulpwns

[newInRobotics]

Just solder a pin on each wire.

[rahulpwns]

most of the pins i am looking are solderless. where can i find some pins that i can solder the wires to? can you post a link?
sorry, i am very new to hardware. i am a programming guy

[newInRobotics]

Well, something like this will do 

[rahulpwns]

Thanks!