Mechanics and Construction > Mechanics and Construction

Connecting wire to the rotating leg

(1/2) > >>

salama:
I'm now starting to design centipede robot. Something pretty much like this:
ZineDyn - Centipede Inspired Robot from KAIST
I'm going to have pressure sensors on each cylindrical metal leg. But my problem is how to connect the wires, because the leg are rotating same direction all the time. So directly just connecting would get the wire cut at some point or jam the leg. Any ideas how to overcome this?

Soeren:
Hi,

That would really scare the daylight out of my GF, but does it only go straight ahead?


--- Quote from: salama on November 10, 2011, 12:36:44 AM ---I'm going to have pressure sensors on each cylindrical metal leg. But my problem is how to connect the wires, because the leg are rotating same direction all the time. So directly just connecting would get the wire cut at some point or jam the leg. Any ideas how to overcome this?

--- End quote ---

Slip rings
A jack plug and socket may be used as slip rings, but will not be nearly a strong as real slip rings.

Alternatively, you could measure the force where each leg is attached, then no wires need to twist.

salama:
Yea I'm planning to make it only forward, real centipedes also go only forward!

I have been thinking the possibility of measuring straight, but probably going with the slip ring. Thank you for your post!

Soeren:
Hi,


--- Quote from: salama on November 10, 2011, 10:43:06 PM ---Yea I'm planning to make it only forward, real centipedes also go only forward!

--- End quote ---
Oh well, I meant straight ahead as opposed to left/right  - seems a little limited if it cannot go further than the length of you largest room.



--- Quote from: salama on November 10, 2011, 10:43:06 PM ---I have been thinking the possibility of measuring straight, but probably going with the slip ring. Thank you for your post!

--- End quote ---
You might wanna check the price on slip rings before you write off other methods, they're a tad expensive.

salama:
After all decided not use slip ring. I will do piston like legs. Think this is the easiest and cheapest solution.

First I will try to make it only forward. Afterward might start thinking of turning right and left.

Navigation

[0] Message Index

[#] Next page