go_away

Author Topic: Wiring  (Read 519 times)

0 Members and 1 Guest are viewing this topic.

Offline Raivin69Topic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
Wiring
« on: December 01, 2011, 01:03:04 AM »

Offline Soeren

  • Supreme Robot
  • *****
  • Posts: 4,672
  • Helpful? 227
  • Mind Reading: 0.0
Re: Wiring
« Reply #1 on: December 01, 2011, 02:10:30 PM »
Hi,

Tring to hook up a tx/rx to a 12 volt linear actuator . Actuator has 3 wires ( a b c) . Ground any one wire and it goes to a preset position. A + b = left. C + b = right. Reciver has 3 pins , +,-,S.

Any idea how to hook them up?
You need a decoder between the receiver and the actuator. This decoder must match the encoder you (need to) use at the transmitting end.
You can either build those with small microcontrollers, or get something like the Holtek encoder/decoder chips.

Further, you need to measure the current in the control wires of the actuator, to see how much driver the decoder needs.
Regards,
Søren

A rather fast and fairly heavy robot with quite large wheels needs what? A lot of power?
Please remember...
Engineering is based on numbers - not adjectives

 


Get Your Ad Here

data_list