go_away

Author Topic: HELP Roborealm Arduino Compatibality?  (Read 1036 times)

0 Members and 1 Guest are viewing this topic.

Offline wise318Topic starter

  • Jr. Member
  • **
  • Posts: 20
  • Helpful? 0
HELP Roborealm Arduino Compatibality?
« on: December 03, 2011, 11:40:27 AM »
Hi, i am using arduino microcontroller 328 with integrated Motor controller, My question here is it possible for me to use Roborealm to navigate the robot and create object follower robot, Because so far I have been programming the robot in Arduino software. thanks

Offline knossos

  • Robot Overlord
  • ****
  • Posts: 278
  • Helpful? 14
Re: HELP Roborealm Arduino Compatibality?
« Reply #1 on: December 03, 2011, 06:20:45 PM »
Definitely not the expert here, since I haven't used Roborealm, but from what I understand it runs on a PC and communicates through your com port or through USB.  An atmega328 does have UART for serial communication and could be connected to a computer com port or USB for Roborealm control.  Caution though, UART cannot be connected directly to a com port due to different voltage levels.
"Never regret thy fall,
O Icarus of the fearless flight
For the greatest tragedy of them all
Is never to feel the burning light."
 
Oscar Wilde

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,658
  • Helpful? 169
    • Society of Robots
Re: HELP Roborealm Arduino Compatibality?
« Reply #2 on: December 03, 2011, 10:54:28 PM »
A few seconds on google produced these:

http://profmason.com/?p=543

Roborealm and Arduino servo mounted camera - Tutorial

 


Get Your Ad Here