2

Author Topic: servos for the 50$ robot  (Read 1060 times)

0 Members and 1 Guest are viewing this topic.

Offline monsieurp0Topic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
servos for the 50$ robot
« on: April 10, 2012, 07:30:09 PM »
hi everyone im new and im planning to build the 50$robots probably with the ir but i dont feel confortable to modify the servo can i buy already modified servos?where?

Offline Gertlex

  • Supreme Robot
  • *****
  • Posts: 744
  • Helpful? 23
  • Nuclear Engineer Roboticist
Re: servos for the 50$ robot
« Reply #1 on: April 10, 2012, 08:53:26 PM »
Here's one example. It quadruple the price, though: http://www.servocity.com/html/hs-311_standard.html

At that point you might as well buy extras if you really think you're going to mess some up :)
I

Offline beachboy612

  • Jr. Member
  • **
  • Posts: 27
  • Helpful? 0
Re: servos for the 50$ robot
« Reply #2 on: June 29, 2012, 12:31:36 PM »
it really isnt that hard.  all you need is crazy glue, a small screwdriver sharp knife, and tweezers.  take gears out w/ tweezer so they arent contaminated and place them on a clean surface.  then saw the pot off using the scissors.  make sure there are no burs as to not interrupt the gears when they are spinning.  send the signal through the microcontroller to the servo.  use tweezers to turn pot until gear stops.  crazy glue it in place, then put servo back together.  very simple.

 


Get Your Ad Here