Author Topic: Question about picture of avrisp mkII  (Read 2083 times)

0 Members and 1 Guest are viewing this topic.

Offline garriwilsonTopic starter

  • Supreme Robot
  • *****
  • Posts: 332
  • Helpful? 0
Question about picture of avrisp mkII
« on: July 26, 2007, 11:16:46 PM »
Ok I've been having trouble programming the atmega8. It says programming flash... FAILED! Then it can't connect to programmer. Here is a picture. Is the bottom arrow pointing to the header pin where pin 1 from the programmer is supposed to go? It's on page 24.

http://www.atmel.com/dyn/resources/prod_documents/AVRISPmkII_UG.pdf
« Last Edit: July 26, 2007, 11:17:20 PM by garriwilson »

Offline klaxxon

  • Jr. Member
  • **
  • Posts: 7
  • Helpful? 0
Re: Question about picture of avrisp mkII
« Reply #1 on: July 27, 2007, 08:39:40 AM »
Yes, I believe the white arrow is pointing to header pin 1.

There is a helpful diagram here:
http://www.societyofrobots.com/robotforum/index.php?topic=1045.msg7804#msg7804

(Do this at your own risk)  Also, I believe that I have hooked my programmer up backwards before, and nothing bad happened.  You could just try connecting it both ways and see which one works.

- Adam

Offline elixier

  • Jr. Member
  • **
  • Posts: 20
  • Helpful? 0
  • http://www.techiesworld.org
Re: Question about picture of avrisp mkII
« Reply #2 on: July 27, 2007, 10:24:42 AM »
As from the figure it is an ISp Programmer so for programming the Microcontroller it depends on the pins to which your circuit which you have configured it goes. in the picture only a dummy circuit has been shown.
http://www.techiesworld.org
  Techies Rules The World

Offline garriwilsonTopic starter

  • Supreme Robot
  • *****
  • Posts: 332
  • Helpful? 0
Re: Question about picture of avrisp mkII
« Reply #3 on: July 27, 2007, 12:33:46 PM »
Adam there is only one problem about that diagram. It shows the other end of the cable not the one I'm supposed to plug in!! Who needs that?

 

Related Topics

  Subject / Started by Replies Last post
6 Replies
5071 Views
Last post July 03, 2007, 06:47:06 PM
by d13
53 Replies
22849 Views
Last post February 12, 2008, 12:26:36 AM
by entwicklungswalther
6 Replies
4704 Views
Last post January 22, 2009, 09:04:16 PM
by airman00
0 Replies
11820 Views
Last post June 23, 2010, 04:21:58 PM
by totalis


Get Your Ad Here

data_list