Electronics > Electronics

Axon II Not Being Recognized By PC

<< < (4/4)

Mastermime:
USB Connectivity is sound.  Tested all five pins for continuity without applying pressure to the pin itself and all connections were good.

Admin:
Ok, we'll see how the programmer goes, and work from there.

I'm a bit stumped at the moment :-\

As a side note, the Axon has three more UART outputs. If you attach a TTL to USB adapter to it (~$15), you'll have USB again.

Mastermime:
Oh good.  I have a FTDI ttl to usb cable. Is it going to be a problem the FTDI cable have the 6 pin connector?  Which UART pins do I connect it to?  Any of them? And is there any interfacing I have to do?  I have already downloaded a driver for FTDI

Mastermime:
Hardware programmer worked!

Admin:

--- Quote from: Mastermime on January 25, 2013, 10:35:21 PM ---Oh good.  I have a FTDI ttl to usb cable. Is it going to be a problem the FTDI cable have the 6 pin connector?  Which UART pins do I connect it to?  Any of them? And is there any interfacing I have to do?  I have already downloaded a driver for FTDI

--- End quote ---

Sorry, somehow I missed this . . .

What FTDI cable are you using? You only need Tx, Rx, power, and ground.

Tx goes to R, Rx goes to T, and ground to G.

Navigation

[0] Message Index

[*] Previous page