Electronics > Electronics

Axon II Not Being Recognized By PC

<< < (2/4) > >>

Mastermime:

--- Quote ---Where did you plug the 12V into? Are you using single or dual power mode?

--- End quote ---
The problem occurred before I even applied voltage to the BAT pin.  As for single or dual power mode, I don't have an answer.  Never chose one or the other.


The link should work now.  It should come up with 'no preview available' but should say 'download' right underneath.

Admin:

--- Quote from: Mastermime on January 22, 2013, 05:30:58 PM ---The link should work now.  It should come up with 'no preview available' but should say 'download' right underneath.

--- End quote ---
It gives me a button for download. But when I click it, after strange flickering, it finally says:


--- Quote ---Google Drive
Cannot enter the application at this time.
--- End quote ---

That's the same error I had before. :-\

Just upload it here instead.

Mastermime:
Hmm that's odd.  Here it is

Admin:
You have quite a lot of stuff attached . . .

So when you wheeled it over, you said the battery was not plugged in, right?

Can you tell me more about your battery monitor circuit?

Mastermime:
The battery was not connected.  Basically the battery monitor circuit, is a simple voltage divider placed immediately after the battery.  The resistors are calculated to divide the voltage to 5v.  The 5v output is  connected to an ADC port on the Axon.  So as the voltage of the batteries decrease, the voltage output will also decrease as well.

Attached is my circuit

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version