Author Topic: Axon II Smoking... need help  (Read 416 times)

0 Members and 1 Guest are viewing this topic.

Offline strat321Topic starter

  • Jr. Member
  • **
  • Posts: 29
  • Helpful? 0
Axon II Smoking... need help
« on: January 23, 2013, 07:29:41 AM »
I had everything on my axon set up correctly, including a servo on b5, a bat with a switch, and a vrbot on uart 2 and a 5v reg, all were connected correctly with ground wire on the outside pin.  However, when i turned it on, it started smoking and the robot in unresponsive.  The power light turns on.  Please help as this is very important for a project.
Thanks in advance

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,653
  • Helpful? 169
    • Society of Robots
Re: Axon II Smoking... need help
« Reply #1 on: January 23, 2013, 11:14:30 PM »
I've sent you an email.

 


Get Your Ad Here