Electronics > Electronics

should i connect both sides of the transistor to the 9v(+) help

<< < (2/2)

ErikY:

--- Quote from: sohailsameja on March 08, 2013, 12:20:04 PM ---that means that the 3rd picture is true.

--- End quote ---

Personally, I would try NOT to use the pictures to make your connections, but rather the circuit diagram.

I always find it difficult to use pictures to make connections. You should be able to follow the circuit diagram and make sure the right connections are made.

This is why I always prefer to use a breadboard to prototype my circuit before soldering, to make sure the circuit diagram works.

I have personaly gotten to the point where I do everything in Eagle, do my schematic in Eagle, than make my board and fab it myself.

I find that it is a better learning experience and I understand the circuit much better, and I end up saving time in the long run as well, but I still prototype before fabricating.

sohailsameja:
Thanks well i checked and its right(acording to the circuit diagram.)

sohailsameja:
SOLVED

Navigation

[0] Message Index

[*] Previous page

Go to full version