Beginners: please read this post and this post before posting to the forum.
0 Members and 1 Guest are viewing this topic.
Listed various places: "Supports RTS/CTS Hardware flow control"
I'm getting nothing with hyperterminal. I get to the actual terminal window, but nothing I type appears on the screen... (As in the window stays completely white, except for the blinking cursor)
ideally you want to switch off all flow control as your servo controller does not use it.are you saying it is not possible to switch off flow control on the bluetooth to serial adapter?
if you are getting a loop back with 2 & 3, and 7 & 8 connected, try leaving 7 & 8 connected (to keep looping the hardware flow controll) and wire up the servocontroller to pin 3 and gnd as normal.note that this will not work for software flow control...dunk.