2

Author Topic: [Arduino] Controlling a self modded continuous servo [Solved]  (Read 348 times)

0 Members and 1 Guest are viewing this topic.

Offline microzeeTopic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Hello, so a while back I built the 50 dollar robot, but decided to use something a little more usable so I bought the arduino. The problem I'm having is controlling my servo. I followed the 50 dollar robot guide, I bought a hs 311 and opened it up and cut the stuff glued etc. Now on my arduino, I want to be able to control the servo speed/direction. In the 50 dollar robot guide it says this:

Send PWM to the servo. You will notice that by telling the servo to go to a particular angle, instead it will rotate at a particular speed. Neat, huh?

So in the arduino IDE I send a particular angle to the servo. Guess what? it rotates at one speed no matter what I send it (direction sometimes changes). Also there's no way to stop the servo.

see this:
http://arduino.cc/en/Reference/Servo

I might need to set:
servo.attach(pin, min, max)
min max values?

The other weird thing is right when I attach the servo without even writing any data to it, it starts spinning. Maybe when I modded it the pot wasn't at 0?

Solved -  The pot wasn't in the right position.
« Last Edit: March 31, 2014, 12:14:08 PM by microzee »

Offline MrWizard

  • Full Member
  • ***
  • Posts: 116
  • Helpful? 0
  • My cylon friend told me a killing joke......
Re: [Arduino] Controlling a self modded continuous servo [Solved]
« Reply #1 on: April 26, 2014, 01:04:46 PM »
Thanks for the feedback.

 


Get Your Ad Here

data_list