go_away

Author Topic: 50 Dollar robot programming problem  (Read 1313 times)

0 Members and 1 Guest are viewing this topic.

Offline ZevooTopic starter

  • Jr. Member
  • **
  • Posts: 26
  • Helpful? 1
50 Dollar robot programming problem
« on: November 17, 2014, 02:09:07 PM »
I tried to program my robot using the latest AVR studio. The first time it did output the Device Signature but I didnt attempt to program the robot. I then try to program but it read the device signature and outputting an error saying that it was unable to enter programming mode.
Can someone help me because I tried for hours and I did not get anywhere.

Offline jkerns

  • Robot Overlord
  • ****
  • Posts: 270
  • Helpful? 12
Re: 50 Dollar robot programming problem
« Reply #1 on: November 17, 2014, 08:13:23 PM »
"Target connector seems to be reversed" - any chance that you plugged the 6 pin connector backwards the second try?
I get paid to play with robots - can't beat that with a stick.

http://www.ltu.edu/engineering/mechanical/bachelor-science-robotics-engineering.asp

Offline ZevooTopic starter

  • Jr. Member
  • **
  • Posts: 26
  • Helpful? 1
Re: 50 Dollar robot programming problem
« Reply #2 on: November 18, 2014, 10:24:04 AM »
I have plugged the programmer both ways. It says that it seems to be reversed both ways...
any other ideas why I am not able to program it?

Offline ZevooTopic starter

  • Jr. Member
  • **
  • Posts: 26
  • Helpful? 1
Re: 50 Dollar robot programming problem
« Reply #3 on: November 18, 2014, 10:25:11 AM »
"Target connector seems to be reversed" - any chance that you plugged the 6 pin connector backwards the second try?

I have plugged the programmer both ways. It says that it seems to be reversed both ways...
any other ideas why I am not able to program it?

 


Get Your Ad Here

data_list