Author Topic: simulator for designing  (Read 1898 times)

0 Members and 1 Guest are viewing this topic.

Offline hanizzTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
simulator for designing
« on: November 21, 2007, 10:20:20 AM »
can anyone please tell me any software that can run hex file into a circuit virtually??

Offline bens

  • Expert Roboticist
  • Supreme Robot
  • *****
  • Posts: 331
  • Helpful? 3
Re: simulator for designing
« Reply #1 on: November 21, 2007, 12:16:36 PM »
This is a case where more information would be helpful (e.g. what microcontroller are you trying to simulate).

Offline airman00

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 3,653
  • Helpful? 21
  • narobo.com
Re: simulator for designing
« Reply #2 on: November 21, 2007, 03:12:20 PM »
I'm using a PIC MCU and I would also like to know where I can get this software from.
Check out the Roboduino, Arduino-compatible board!


Link: http://curiousinventor.com/kits/roboduino

www.Narobo.com

Offline Steel_monkey

  • Full Member
  • ***
  • Posts: 85
  • Helpful? 0
Re: simulator for designing
« Reply #3 on: November 21, 2007, 03:44:17 PM »
Not an ad. As I know, the most widespread MCU simulator is PROTEUS. You can virtually run your hex at AVRs, PICs and even ARM7. Analog circuits simulation is not perfect, but acceptable. There are build-in SPI and I2C debuggers, signal generator, scope, logic analyzer and so on. Look for prices at designers` site : http://www.labcenter.co.uk/
Also world-wide-web is big place…

 


Get Your Ad Here