$50 robot - atmega8 - int0 & int1

[pomprocker]

What are these ports for on the servo bus? I plugged a servo into them, and obviously nothing happend.

Also, Can the photosensors be plugged into any port on the sensor bus?

[ed1380]

the servo ports in the code are portd 0 - portd4
the photosensors can be plugged into any one you'd just have to change the code a bit.
are you sure the atmega8 is programmed correctly? are the servo's plugged into the correct pins?

[pomprocker]

I learned from reading posts that the ports on the servo bus are controlled by the programming, not the actually way its soldered. I figured this out when I read ahead to the UART guide.

Right now I have only had the modify servo hex loaded. I should wait until my robot is fully programmed before asking such questions.

[Admin]

int 0 and int 1 are interrupts.

If you program them in, they can be useful for neat stuff. Just google them up to learn more.