go_away

Author Topic: Should the SDA line on i2c bus be high when not in use?  (Read 1073 times)

0 Members and 1 Guest are viewing this topic.

Offline stopgoTopic starter

  • Full Member
  • ***
  • Posts: 58
  • Helpful? 0
Should the SDA line on i2c bus be high when not in use?
« on: April 17, 2008, 10:24:34 PM »
I'm trying to debug an i2c device that I'm using.  I have 2 i2c pins coming out of my uc, SCL and SDA.  SCL is high but SDA is low.  SDA should also be high when no data is being transmitted, right?
Logged

Offline stopgoTopic starter

  • Full Member
  • ***
  • Posts: 58
  • Helpful? 0
Re: Should the SDA line on i2c bus be high when not in use?
« Reply #1 on: April 17, 2008, 10:41:52 PM »
Arrrrrgh.  Many hours of stress could have been avoided had I realized I was looking at the wrong pin.  SDA is indeed high.  nm!
Logged
 

Related Topics

  Subject / Started by Replies Last post
17 Replies
6100 Views 		Last post November 24, 2008, 05:53:02 PM
by AdvsNoob
6 Replies
1109 Views 		Last post July 28, 2009, 08:02:56 AM
by awally88
9 Replies
1974 Views 		Last post September 07, 2009, 06:34:07 AM
by Admin
0 Replies
964 Views 		Last post May 15, 2011, 04:04:12 AM
by Tommy


Get Your Ad Here