Author Topic: Cheap Linear Servo?  (Read 16738 times)

0 Members and 1 Guest are viewing this topic.

Offline xamirxTopic starter

  • Jr. Member
  • **
  • Posts: 8
  • Helpful? 0
Cheap Linear Servo?
« on: July 13, 2008, 05:11:18 AM »
Hi everyone

I need a linear actuator for my thesis project. I need to implement a robot eyeball system with 'tendons'. the actuators from Firgelli.com would be perfect, the only problem being that they cost about $60 each! Is there a much cheaper alternative? Or is there a way to convert a standard servo to linear motion?

Somebody told me to check out old 3.5 Floppy drives cause they have a linear mechanism of sorts? Are there any other 'scrapyard' type devices where i can salvage a linear servo or actuator?

Thanks

Amir


Offline BANE

  • Supreme Robot
  • *****
  • Posts: 639
  • Helpful? 4
  • E=roboticsC^2
Re: Cheap Linear Servo?
« Reply #2 on: July 13, 2008, 10:03:10 AM »
You could use the device in a CD player that moves the laser back and forth,  maybe you could attach a linear potentiometer on it somehow and use a servo h-bridge.

Bane

Offline Commanderbob

  • Robot Overlord
  • ****
  • Posts: 146
  • Helpful? 2
  • Embeddedmicro.com
Re: Cheap Linear Servo?
« Reply #3 on: July 14, 2008, 07:17:50 PM »
You can always attach control rods to servos. That lets you push/pull with them. Almost every RC vehicle uses them for turning to some kind of motion. Here is a picture of one.
Justin

Offline Trumpkin

  • Supreme Robot
  • *****
  • Posts: 1,177
  • Helpful? 5
Re: Cheap Linear Servo?
« Reply #4 on: July 15, 2008, 01:18:44 PM »
try ebay.
Robots are awesome!

Offline emmannuel

  • Full Member
  • ***
  • Posts: 87
  • Helpful? 0
Re: Cheap Linear Servo?
« Reply #5 on: July 15, 2008, 02:06:06 PM »
OMFG I've been looking for solutions like those that were economical and worked.....

The linear actuator using the DC motor is awesome.. now I feel dumb for never thinking of those ideas :P

Offline bulkhead

  • Full Member
  • ***
  • Posts: 102
  • Helpful? 0
Re: Cheap Linear Servo?
« Reply #6 on: July 16, 2008, 01:04:40 AM »
Control rods with servos will probably be the easiest and cheapest way to do it using standard $10 servos.  Look at this picture:

The motion of the rod is essentially linear, especially if you just use it to pivot a joint that only has 1 degree of freedom (like a door hinge).  This route will require some careful thought about where the pivot points are because the available pushing/pull force of the servo is a sine/cosine function, where the servo could end up with zero mechanical advantage.  If you go this route go to a hobby shop and look at the steering mechanism on any RC car.  You will need "rod ends" (http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHGB7&P=7) from any hobby shop carrying RC car parts and a ~1/8" threaded rod from any hardware store (cut to the length you need).

 


Get Your Ad Here