Author Topic: I am a beginner on: Actuators!  (Read 2508 times)

0 Members and 1 Guest are viewing this topic.

Offline MeriemTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
I am a beginner on: Actuators!
« on: January 16, 2007, 06:29:54 AM »
Hello,

I have just registered, so I am a New member ;)

I was just wondering if I could help regarding electromechanical Actuators,...info...from your experience

especially on ACTUATOR COUPLING issues.

I am runing experiement that involves that.

Thanks for helping and your time!

Meriem:)
« Last Edit: January 16, 2007, 09:19:52 AM by Admin »

Offline Militoy

  • Expert Roboticist
  • Full Member
  • *****
  • Posts: 111
  • Helpful? 0
Re: I am a beginner on: Actuators!
« Reply #1 on: January 16, 2007, 01:42:35 PM »
What kinds (and sizes) of actuators does your experiment involve? I would venture a guess that most of the participants in this forum are using mainly R/C servos, linked using tie-rods, and small PM DC motors. Coupling issues become more critical, for both linear and rotary motion, as service loads and actuation distances are increased – and in more harsh environments (such as underwater, or in dirty industrial areas).

 


Get Your Ad Here

data_list