go_away

Author Topic: blackfin expansion board  (Read 1369 times)

0 Members and 1 Guest are viewing this topic.

Offline vidamTopic starter

  • Supreme Robot
  • *****
  • Posts: 423
  • Helpful? 1
  • Robotronics.org
blackfin expansion board
« on: July 25, 2008, 10:27:41 PM »
the pins on the greenexpansion board are confusing me.

it says I need pins 3 and 4 for uart  on this post:

http://www.surveyor.com/cgi-bin/yabb2/YaBB.pl?num=1217041456/2#2

but looking at your picture you use pin 2 and 3

3        TX0                Matchport RX1 (pin 9) + XBee Din (pin 3)
4        RX0                Matchport TX1 (pin 5) + XBee Dout (pin 2)

you said to look at the last part of the 2 sentences. I'm not using XBee. That is some wireless connection?

Offline vidamTopic starter

  • Supreme Robot
  • *****
  • Posts: 423
  • Helpful? 1
  • Robotronics.org
Re: blackfin expansion board
« Reply #1 on: July 25, 2008, 10:51:43 PM »
never mind I get it the expansion board layout now. It is a bit confusing. I did not know what an XBee header is.

sigh  :-\

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,663
  • Helpful? 169
    • Society of Robots
Re: blackfin expansion board
« Reply #2 on: July 25, 2008, 10:56:10 PM »
yea I was a bit confused at first too. My image makes it easier :P


 


Get Your Ad Here