Author Topic: Is 3mm Sintra enough to support 5 lbs?  (Read 2548 times)

0 Members and 1 Guest are viewing this topic.

Offline MaltiKTopic starter

  • Robot Overlord
  • ****
  • Posts: 300
  • Helpful? 2
Is 3mm Sintra enough to support 5 lbs?
« on: August 23, 2008, 03:24:20 PM »
... Or how much do you think it can support on its own? let say making a shelf with only the 3mm sintra
Warranty

Offline Gertlex

  • Supreme Robot
  • *****
  • Posts: 744
  • Helpful? 23
  • Nuclear Engineer Roboticist
Re: Is 3mm Sintra enough to support 5 lbs?
« Reply #1 on: August 23, 2008, 03:32:57 PM »
And what is Sintra?
I

Offline MaltiKTopic starter

  • Robot Overlord
  • ****
  • Posts: 300
  • Helpful? 2
« Last Edit: August 23, 2008, 05:12:56 PM by MaltiK »
Warranty

Offline ed1380

  • Supreme Robot
  • *****
  • Posts: 1,478
  • Helpful? 3
Re: Is 3mm Sintra enough to support 5 lbs?
« Reply #3 on: August 23, 2008, 09:38:08 PM »
depends on how much space between the supports.
Problems making the $50 robot circuit board?
click here. http://www.societyofrobots.com/robotforum/index.php?topic=3292.msg25198#msg25198

Offline MaltiKTopic starter

  • Robot Overlord
  • ****
  • Posts: 300
  • Helpful? 2
Re: Is 3mm Sintra enough to support 5 lbs?
« Reply #4 on: August 24, 2008, 04:16:26 AM »
Lets say 6 inches
Warranty

Offline RobD

  • Full Member
  • ***
  • Posts: 64
  • Helpful? 0

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,660
  • Helpful? 169
    • Society of Robots
Re: Is 3mm Sintra enough to support 5 lbs?
« Reply #6 on: September 01, 2008, 04:05:25 PM »
Depends on length and width, and where the force is applied. Also depends on how you define 'support'.

Not breaking? Or just serious bending? Perhaps zero bending (impossible)?

 


Get Your Ad Here