go_away

Author Topic: have you used Futaba S3003 and S3102?  (Read 1927 times)

0 Members and 2 Guests are viewing this topic.

Offline AdminTopic starter

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,667
  • Helpful? 170
    • Society of Robots
have you used Futaba S3003 and S3102?
« on: September 01, 2008, 12:00:45 PM »
Anyone used the Futaba S3003 and/or S3102 with comments on them? Either break or burn out on you?

Also, does anyone know if the Futaba digital servos hold position when powered (without a signal) like Hitec servos do?

Offline mklrobo

  • Robot Overlord
  • ****
  • Posts: 153
  • Helpful? 1
  • From Dream to Design at the speed of Imagination!
Re: have you used Futaba S3003 and S3102?
« Reply #1 on: January 26, 2015, 09:26:28 AM »
 :) Hello!
I would require more information. When I was in an industrial setting, I had access to information
regarding lots of motors. Do you have a link to the specific motor? Keep me posted.....   ;D

Offline mklrobo

  • Robot Overlord
  • ****
  • Posts: 153
  • Helpful? 1
  • From Dream to Design at the speed of Imagination!
Re: have you used Futaba S3003 and S3102?
« Reply #2 on: February 11, 2015, 04:25:00 PM »
 :) Hello!
 I looked up the motors in question, and they are used in RC boats, planes,
and wheeled vehicles. The reviews on the internet give them a good performance
rating, and they are used quite frequently in robotics projects. I have not located any
reports of burn outs, or, if the motor will hold its position. Will have to look further into it.
Keep me posted......   ;D ;D ;D

 


Get Your Ad Here

data_list