Ok, so heres the pseudoschematic:
Windows Controller -> Laptop -> C Code -> Hyperterminal -> Bluetooth Dongle -> BlueSMIRF -> MCU -> Actuators
Does anyone know of any C code that basically transmits packets of information (TX) from bluetooth to a bluetooth modem with UART (RX). I know I will have to configure the Baud rate and everything, and I think Hyperterminal can help with this but I am not sure.
What I basically want to do is use a standard Windows Controller on my Vista Laptop and when I use the left trigger or so, the motors on say Output 1 will go to high, and when I let go of the trigger, it will go to low.
I will have to read what kind of packets(?) are sent when each button is pushed on the controller?
I am thinking what I have to do is interface a controller with Hyperterminal, configure Hyperterminal to send packets thru the bluetooth dongle, and like I said, thru UART, set each output to high or low based on the pressed button
Is this practical or has been done?
Can anyone help me with this?