go_away

Author Topic: Verification request for schematic of micromouse  (Read 2563 times)

0 Members and 1 Guest are viewing this topic.

Offline nitingTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
Verification request for schematic of micromouse
« on: December 20, 2008, 02:24:01 AM »
Hello everyone!!!
I am making a bot called micromouse which is an autonomouse maze solving robot. I am using Sharp IR GP2D12 and GP2D120 as side and front sensors. I made two schematics one based on SLA7024M manufactured by Sanken Electronics and one on ULN2803 by Toshiba as the motor drivers. The microcontroller I am using is PIC18F452. The schematics for both the drivers are attached. Could anyone please verify the schematic for correctness as I am totally new to electronics and have done the schematic based on what I read and found on other schematics.
Thanking you in advance
niting
Logged

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,696
  • Helpful? 173
    • Society of Robots
Re: Verification request for schematic of micromouse
« Reply #1 on: January 26, 2009, 02:08:21 AM »
I'm probably answering this too late but . . .

The capacitor for the Sharp IR is wrong. It needs to short 5V with ground.

You also need a voltage regulator and filter caps for your 5V going to your PIC.

I'm not familiar with the other chips and too lazy to look up and study the datasheets . . . ;D
Logged
 

Get Your Ad Here