go_away

Author Topic: Axon to stepper motor controller  (Read 3038 times)

0 Members and 1 Guest are viewing this topic.

Offline amscrplayaTopic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Axon to stepper motor controller
« on: December 23, 2008, 06:59:42 PM »
My stepper motor controller (http://www.probotix.com/manuals/SideStep_manual.htm) has a 4 pin input for a microcontroller (Enable, step, direction, ground) but the axon microcontroller only has 3 pin outputs. What do I need to do to use the axon with this 4 pin motor controller? Do I need to use two outputs from the axon?

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,657
  • Helpful? 169
    • Society of Robots
Re: Axon to stepper motor controller
« Reply #1 on: December 25, 2008, 10:49:55 AM »
You will need to use three digital output pins, and ground.

For example, the far left pins on A4, A5, and A6, plus ground from any of the far right pins.

Use this code:
http://www.societyofrobots.com/axon/axon_function_list.shtml#digital_output

 


Get Your Ad Here