go_away

Author Topic: Servo modification source code HELP!!!  (Read 1460 times)

0 Members and 1 Guest are viewing this topic.

Offline geek1Topic starter

  • Full Member
  • ***
  • Posts: 64
  • Helpful? 0
Servo modification source code HELP!!!
« on: January 01, 2009, 08:48:15 AM »
Can someone please post source code to center a servo for modification?
C is the language I will be using.




Thanks.
« Last Edit: January 04, 2009, 08:08:09 AM by geek1 »
Logged
New roboticist and lovin it ;D ;D ;D

Offline airman00

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 3,653
  • Helpful? 21
  • narobo.com
Re: Servo modification source code
« Reply #1 on: January 01, 2009, 11:15:04 AM »
Which microcontroller
Logged
Check out the Roboduino, Arduino-compatible board!


Link: http://curiousinventor.com/kits/roboduino

www.Narobo.com

Offline geek1Topic starter

  • Full Member
  • ***
  • Posts: 64
  • Helpful? 0
Re: Servo modification source code
« Reply #2 on: January 01, 2009, 01:13:56 PM »
Roboduino/ATmega8
Logged
New roboticist and lovin it ;D ;D ;D

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,585
  • Helpful? 169
    • Society of Robots
Re: Servo modification source code HELP!!!
« Reply #3 on: January 09, 2009, 10:08:38 PM »
Its on this page:
http://www.societyofrobots.com/actuators_modifyservo.shtml

ATmega8:
http://www.societyofrobots.com/downloads/hold_servo.hex

where else? :P

btw, the Roboduino doesn't use the ATmega8 ;D
Logged
 

Related Topics

  Subject / Started by Replies Last post
8 Replies
6587 Views 		Last post January 13, 2008, 03:02:48 PM
by junior000
14 Replies
3663 Views 		Last post February 10, 2009, 01:10:12 PM
by Joesavage1
6 Replies
2053 Views 		Last post February 22, 2010, 11:35:18 PM
by logicguy
1 Replies
1399 Views 		Last post February 21, 2012, 10:49:45 PM
by joe61


Get Your Ad Here