go_away

Author Topic: wavefront algorithm on iRobot Create  (Read 2672 times)

0 Members and 1 Guest are viewing this topic.

Offline wolffanTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
wavefront algorithm on iRobot Create
« on: March 03, 2009, 10:11:57 AM »
I am trying to implement the wavefront algorithm (written by the admin of this site) onto my iRobot Create.  The admin wrote the code for his iRobot Create, so I don't think I should have too much trouble.  However, when I compile the code it comes to 16,000+ bytes, but I think I am only allowed ~14,000 bytes on the SRAM.    Has anybody run into this same problem?

Thanks,
-Andy

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,659
  • Helpful? 169
    • Society of Robots
Re: wavefront algorithm on iRobot Create
« Reply #1 on: March 15, 2009, 09:14:52 AM »
I am trying to implement the wavefront algorithm (written by the admin of this site) onto my iRobot Create.  The admin wrote the code for his iRobot Create, so I don't think I should have too much trouble.  However, when I compile the code it comes to 16,000+ bytes, but I think I am only allowed ~14,000 bytes on the SRAM.    Has anybody run into this same problem?
Actually you are only allowed I think 4kb RAM on the ATmega168 . . . but that's not a problem because this is ROM you see, not RAM ;D

(AVR Studio is smart, it'll give you an error if you run out of memory)

 


Get Your Ad Here

data_list