Author Topic: what kind of wire? (Read 1413 times)

***bacon*** · « **on:** March 25, 2009, 09:09:42 PM »

ok guys im a complete noob at robotics and this is a stupid question but what size and guage wire should i use? thanx ***bacon***'

SmAsH · « **Reply #1 on:** March 25, 2009, 11:19:32 PM »

*sigh* but just to help a noob out, 24-28gauge for smaller amperage. how many amps do you think will go through the wire? what will this be used for?

***bacon*** · « **Reply #2 on:** March 26, 2009, 06:07:59 AM »

This will be used for the circutryin my 50$ robot

SmAsH · « **Reply #3 on:** March 26, 2009, 02:23:50 PM »

24-28 would be idle but you can use prettymuch anything but its just harder to solder on if its too big/too small.

Admin · « **Reply #4 on:** April 08, 2009, 12:35:47 AM »

depends on current going through the wire

SmAsH · « **Reply #5 on:** April 08, 2009, 12:37:10 AM »

This will be used for the circutryin my 50$ robot

sorry admin, i went off this as i didnt think too much current would be going through these wires. sorry my bad

Society of Robots - Robot Forum