go_away

Author Topic: Cart Robot  (Read 1294 times)

0 Members and 1 Guest are viewing this topic.

Offline blackjack102Topic starter

  • Beginner
  • *
  • Posts: 2
  • Helpful? 0
Cart Robot
« on: May 29, 2009, 08:42:09 PM »
I saw this http://www.robotshop.us/phidgetstepper-unipolar-4-motor.html and wanted to build basic "cart robot". It could support 100 lbs. I looked many material from this forum like http://www.sdp-si.com/. However, I could not find nice angle clamp. I found only http://www.servocity.com/html/90o_clamping_tube_hub.html, but it is not enough information or good enough for the cart.

I could use shafts to build the cart; however, I do not want to weld them. I want to build a cart and can change the structure if needs to. I am not sure what is called clamp or something that you could suggest.

Thank you so much

I made in 3d model:



Logged

Offline airman00

  • Contest Winner
  • Supreme Robot
  • ****
  • Posts: 3,653
  • Helpful? 21
  • narobo.com
Re: Cart Robot
« Reply #1 on: May 29, 2009, 09:32:30 PM »
Maybe use some piping and drill into it?
Sort of like this
Logged
Check out the Roboduino, Arduino-compatible board!


Link: http://curiousinventor.com/kits/roboduino

www.Narobo.com

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,667
  • Helpful? 170
    • Society of Robots
Re: Cart Robot
« Reply #2 on: June 25, 2009, 05:16:58 AM »
It will probably be cheapest to just custom make your own.
Logged
 

Get Your Ad Here

data_list