Author Topic: How to debug RF Transmitter / Receiver  (Read 1629 times)

0 Members and 1 Guest are viewing this topic.

Offline silo_xtremeTopic starter

  • Robot Overlord
  • ****
  • Posts: 172
  • Helpful? 0
  • I really love robots, they keep me awake at night.
How to debug RF Transmitter / Receiver
« on: November 10, 2009, 04:57:07 PM »
Hi Everyone,

What's a good way to debug a, RF TX and RX pair?   I'm not sure if I have I have a problem on the TX or RX side and pointers would be great!




Offline Spoil9

  • Robot Overlord
  • ****
  • Posts: 155
  • Helpful? 1
Re: How to debug RF Transmitter / Receiver
« Reply #1 on: November 10, 2009, 06:54:59 PM »
Not sure how to do it with out either a freq meter to tell if the TX is transmitting, or another TX/RX pair so you can swap out one piece at a time.
Knowledge is Power. Power Corrupts. Study Hard. Be Evil.

Offline kd5kfl

  • Full Member
  • ***
  • Posts: 72
  • Helpful? 1
Re: How to debug RF Transmitter / Receiver
« Reply #2 on: November 10, 2009, 07:51:21 PM »
434 mhz transmitter should be picked up on any scanner. that's how you check out that end.

Offline Spoil9

  • Robot Overlord
  • ****
  • Posts: 155
  • Helpful? 1
Re: How to debug RF Transmitter / Receiver
« Reply #3 on: November 10, 2009, 09:17:18 PM »
I didn't see that it was 434 MHz unless you're just throwing out that little useful bit of info.
Knowledge is Power. Power Corrupts. Study Hard. Be Evil.

 


Get Your Ad Here

data_list