2

Author Topic: How to debug RF Transmitter / Receiver  (Read 1639 times)

0 Members and 1 Guest are viewing this topic.

Offline silo_xtremeTopic starter

  • Robot Overlord
  • ****
  • Posts: 172
  • Helpful? 0
  • I really love robots, they keep me awake at night.
How to debug RF Transmitter / Receiver
« on: November 10, 2009, 04:57:07 PM »
Hi Everyone,

What's a good way to debug a, RF TX and RX pair?   I'm not sure if I have I have a problem on the TX or RX side and pointers would be great!




Offline Spoil9

  • Robot Overlord
  • ****
  • Posts: 155
  • Helpful? 1
Re: How to debug RF Transmitter / Receiver
« Reply #1 on: November 10, 2009, 06:54:59 PM »
Not sure how to do it with out either a freq meter to tell if the TX is transmitting, or another TX/RX pair so you can swap out one piece at a time.
Knowledge is Power. Power Corrupts. Study Hard. Be Evil.

Offline kd5kfl

  • Full Member
  • ***
  • Posts: 72
  • Helpful? 1
Re: How to debug RF Transmitter / Receiver
« Reply #2 on: November 10, 2009, 07:51:21 PM »
434 mhz transmitter should be picked up on any scanner. that's how you check out that end.

Offline Spoil9

  • Robot Overlord
  • ****
  • Posts: 155
  • Helpful? 1
Re: How to debug RF Transmitter / Receiver
« Reply #3 on: November 10, 2009, 09:17:18 PM »
I didn't see that it was 434 MHz unless you're just throwing out that little useful bit of info.
Knowledge is Power. Power Corrupts. Study Hard. Be Evil.

 


Get Your Ad Here