go_away

Author Topic: Basic Stamp 2 - 10A Dual H-Bridge connection  (Read 1898 times)

0 Members and 1 Guest are viewing this topic.

Offline conqueror06Topic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Basic Stamp 2 - 10A Dual H-Bridge connection
« on: December 15, 2009, 09:45:27 AM »
Hello! 8)

I bought few days ago a 10A Dual H-Bridge from
http://www.roboticsconnection.com/p-77-10-amp-dual-h-bridge.aspx.

I want to ask if it is possible to connect the H-Bridge to Basic Stamp 2 for controlling two DC motors.
What are the precise connections between Board of Education and 10A Dual H-Bridge?
Finally, how can I program it?

Sorry if I bore you with my questions, but I'm just a begginer!!! ;D
« Last Edit: December 15, 2009, 09:50:17 AM by conqueror06 »

Offline conqueror06Topic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Re: Basic Stamp 2 - 10A Dual H-Bridge connection
« Reply #1 on: December 15, 2009, 04:06:08 PM »
Hello! 8)

I bought few days ago a 10A Dual H-Bridge from
http://www.roboticsconnection.com/p-77-10-amp-dual-h-bridge.aspx.

I want to ask if it is possible to connect the H-Bridge to Basic Stamp 2 for controlling two DC motors.
What are the precise connections between Board of Education and 10A Dual H-Bridge?
Finally, how can I program it?

Sorry if I bore you with my questions, but I'm just a beginner!!! ;D

Offline conqueror06Topic starter

  • Beginner
  • *
  • Posts: 3
  • Helpful? 0
Re: Basic Stamp 2 - 10A Dual H-Bridge connection
« Reply #2 on: December 15, 2009, 04:09:59 PM »
The pins of the H-Bridge:

Vcc - Logic Vcc (+5V)
Gnd
DIR1 - Motor direction for motor 1 (High/Low)
PWM1 - PWM Input for motor 1
DIR2 - Motor direction for motor 2 (High/Low)
PWM2 - PWM Input for motor 2
Enbl. - H-Bridge Enable
« Last Edit: December 15, 2009, 04:13:44 PM by conqueror06 »

 


Get Your Ad Here