Author Topic: Question about Taurus 2  (Read 4114 times)

0 Members and 1 Guest are viewing this topic.

Offline SomchayaTopic starter

  • Robot Overlord
  • ****
  • Posts: 180
  • Helpful? 0
  • You know it's cute!
Question about Taurus 2
« on: January 23, 2007, 12:19:29 AM »
Hey! I haven't been to SoR for a while, and I noticed a lot of new tutorials! I've read through most of them and I think you did a great job!

Anyway, I was looking at the page about the Taurus 2, and I was wondering about the transparent plastic rods that connect the top servo to the bottom servo for each wheel. Was there a reason you did this instead of moving the top servo down, right above the bottom servo?
Somchaya - Back after a year of misc things

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: Question about Taurus 2
« Reply #1 on: January 24, 2007, 08:23:53 AM »
thanks! my new tutorials are soooo much better than my old ones. ive even started to completely rewrite my old ones.

to be honest, taurus 2 was such a badly planned out robot . . . most of what i did was because i didnt know any other way to do it. i was very much a beginner back then . . .

there was no particular reason the servos were up there. that rotating rod of clear plastic was wobbly and somewhat mechanically complicated. thinking about it now, i think your idea is better. :P


Get Your Ad Here