Author Topic: Fanuc I/O  (Read 1618 times)

0 Members and 1 Guest are viewing this topic.

Offline denmaintTopic starter

  • Beginner
  • *
  • Posts: 1
  • Helpful? 0
Fanuc I/O
« on: July 15, 2009, 07:06:09 PM »
I am a beginner here and with robots and I could use some help.  I have a Fanuc robot with an RJ2 controller.  I am trying to configure the Process I/O PCB.  I don't understand what the starting point means in the config menu.  I understand what the rack and slot configs are, just not the starting point.   Any help would be greatly appreciated.  Thanks

Offline Admin

  • Administrator
  • Supreme Robot
  • *****
  • Posts: 11,703
  • Helpful? 173
    • Society of Robots
Re: Fanuc I/O
« Reply #1 on: July 21, 2009, 01:30:46 PM »
Not entirely sure to what 'starting point' is referenced to in the manual . . .

I would assume thats the robot arm default position. For example, when you boot up the arm, where do you want to arm to always start at?

 


Get Your Ad Here