Buy an Axon, Axon II, or Axon Mote and build a great robot, while helping to support SoR.
0 Members and 1 Guest are viewing this topic.
OK, you suggest me to buy which chargers http://robokits.co.in/shop/index.php?main_page=index&cPath=13Thanks
I will use 2 motors http://robokits.co.in/shop/index.php?main_page=product_info&cPath=2&products_id=247&zenid=982d36c3dbc1594633528a42af15cce2 of 375RPM and Li..battery http://robokits.co.in/shop/index.php?main_page=product_info&cPath=13&products_id=69&zenid=6ba297ea6900ec4fc09d1f8e8648af0b......
Do You remember this post? Good. Now, follow the link and read Wink
It show Compatible Chargers * Li-Ion / Li-Po Intelligent Fast Charger for 2-3 Cell Battery(RKI-1122) * Li-Ion / Li-Po 2A 3 Cell Fast Charger * IMAX B6 5A Multipurpouse Battery Charger
should i buy that Rs 650/. cost one??
OK, i have downloaded Google sketch up software also....
One thing more charger are asking for input of 15v not 220V why??
Do you think the chargers deserve the cost or not??
Here some CAD images please tell any changes to do........
If You think that it's fine, then it is fine. You do realize that frame you've designed is not symmetrical, don't You?
As it was my first attemt to use the CAD i can see it is not geometrical ......Please tell any changes to do in the designing making it more col.
You are fast, well done Smiley
Does it have a caster wheel at the back?
What are You going to use for line recognition?
Set Pin 5 OR 7 (In1 OR In2) to run motor1 (Pin 10 OR 11 - motor2) to one side OR the other (NEVER set both Pins high at the same time)
QuoteSet Pin 5 OR 7 (In1 OR In2) to run motor1 (Pin 10 OR 11 - motor2) to one side OR the other (NEVER set both Pins high at the same time)First thanks for reply.........OK, the i have done both pin higher just for checking....!!after that i have connected one to -ve 5V and another to GND vice versa.the voltage on multimeter is working well but i think current is very low.....i think in few mA...
If it was soldering problem, did You fix it? Is it working as it is supposed to work now?
when i connect the enable to gnd motor still run in same direction....