Hi all,
I am reading this datasheet on atmega 2561 to find out how to set the fuses properly.
http://www.atmel.com/dyn/resources/prod_documents/doc2581.pdfTable 6 on page 4 states the following.
Table 6. BOD fuse configuration on ATmega1281/2561
BODLEVEL 2..0 | Typical VBOT [V]
111 | BOD disabled
110 | 1.8
101 | 2.7
100 | 4.3
The options inside of AVR Studio 4 are:
Brown out detection disabled; [BODLEVEL=111]
Brown out detection level at VCC=1.8 V; [BODLEVEL=110]
Brown out detection level at VCC=2.7 V; [BODLEVEL=101]
Brown out detection level at VCC=4.3 V; [BODLEVEL=100]
On-Chip Debug Enabled; [OCDEN=0]
JTAG Interface enabled; [JTAGEN=0]
Serial program downloading (SPI) enabled; [SPIEN=0]
Watchdog timer always on [WDTON=0]
Preserve EEPROM memory through the Chip Erase cycle; [EESAVE=0]
Boot Flash section size=512 words Boot start address=$1FE00; [BOOTSZ=11]
Boot Flash section size=1024 words Boot start address=$1FC00; [BOOTSZ=10]
Boot Flash section size = 2408 words Boot start address=$1F800 [BOOTSZ=01]
Boots Flash section size = 4096 words Boot start address = $1F00; [BOOTSZ=00]; default
Boot reset vector Enabled (default address=$0000); BOOTRST=0
Divide clock by 8 internally [CKDIV8=0]
Clock output on PORTE7 [CKOUT=0]
Ext. Clock; Startup-time: 6 CK + 0 ms
rather than type out the rest of the fuse options here is the photo
What is the best way to interpret the datasheets to figure out the fuse settings I must set?